Coolbot Heater Cable. Locating and connecting a Frigidaire A/C's Secondary Sensor to your In this section, you'll learn how to install and program your CoolBot properly The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up.
Frost King 9 ft. Automatic Electric Heat Cable KitHC9A The Home Depot from www.homedepot.com
Installing the CoolBot Make sure that your CoolBot kit is complete The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up.
Frost King 9 ft. Automatic Electric Heat Cable KitHC9A The Home Depot
"Heater" cable replacement for any CoolBot where all the cables plug at the bottom A replacement heater cable for any CoolBot in which the cables plug at the bottom. Frequently Asked Questions Common questions about the CoolBot, A/Cs, Uses, humidity, winter use, etc.
Frost King 6 ft. Electric Water Pipe Heat CableHC6A The Home Depot. Asurion Complete Protect: One plan covers all eligible past and future purchases (Renews Monthly Until Cancelled) for $16.99/monthAmazon.com: Coolbot Heater with External Plug Connector The 2 Secondary Sensor thermostats stand free (in this case they worked OK just hanging free for a set temperature of 44°F).
MGRAS 12V DC Low Voltage Heater Cable Kits Recreational. A heater light pulsing slowly is completely normal! That means the CoolBot is trying to keep the warm to "fool" the A/C's temperature sensor and cool the room Heater light pulsing slowly (or ON) = CoolBot is calling for Cool Remember! The Heater Cable is NOT for defrosting the A/C.